Mitox CS50 Manual do Operador descarregar pdf (Página 11)

CS45 / CS50 / CS56 Chainsaw

Original Instructions Version April 12

Installing the Guide Bar and Chain

Open the box and install the guide bar and the saw chain on the power unit as follows:

The saw chain has very sharp edges. Use thick protective gloves for safety.

1. Pull the guard towards the front handle to check that the chain brake is not on.

2. Loosen the nuts and remove the chain cover.

3. Install the spike to the power unit (dependent on model).

4. Remove and discard the plastic packer (3) located on the bar studs.

5 . Fit the guide bar over the bar bolts.

Figure 1. Figure 2.

Chain Direction

6. Figure 1 Fit the chain to the drive sprocket and while tting the saw chain around the guide bar,

adjust the position of the chain tensioner located in the side cover (2) to t into the hole (1) in the

guide bar.

7. Fit the chain cover to the power unit and fasten the nuts nger tight.

8. Figure 2 While holding up the tip of the bar, adjust the chain tension by turning the tensioner

screw until the chain does not sag from the underside of the guide bar.

9. Tighten the bar nuts securely with the bar held up to 12/15N.M, then check the chain for smooth

rotation and proper tension while moving the chain by hand.

Note: A new chain will expand in length at the beginning of use. Check and readjust the tension

frequently, as a loose chain can easily derail or cause rapid wear to itself and the guide bar.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Sem comentários

Mitox CS50 Manual do Operador Página 11